Reconstituting Xeomin.
You will need a clean workspace,
your alcohol wipe, diluent saline,
and three types of syringes.
Next, find your Xeomin vial
available in 50, 100,
or 200 unit doses.
For additional injection
information, consult Section 2
in the prescribing information.
Select a dose of Xeomin and inspect
the vial.
Xeomin is a sterile white to off
-white powder before reconstitution.
Use saline to reconstitute Xeomin.
Clean the rubber stopper
of both the saline and Xeomin vial
with an alcohol wipe.
Important!
Do not pry or pop the cap off
the Xeomin vial, as it is
vacuum packed and doing so may
result in Xeomin powder dispersing
into the air.
Draw the desired volume of saline
into the syringe, then vertically
insert the needle into the Xeomin
vial.
The vacuum within should draw most
of the saline into the Xeomin vial.
If the vacuum is not present, the
Xeomin vial should be discarded.
Gently inject any remaining saline.
For diluent volumes and
instructions.
including reconstitution of volumes
greater than five milliliters,
consult Table 5 in the prescribing
information.
After the needle is removed, the
Xeomin vial should be swirled and
flipped to mix.
All powder should be dissolved into
the saline.
Reconstituted Xeomin should be
clear, colorless, and free
of particulate matter.
Reconstituted Xeomin should be used
for only one injection session
and for one patient only.
To view details on intramuscular
and intraglandular injection,
consult the prescribing information.
Reconstituted Xeomin can be used up
to 24 hours after dilution,
if stored in a refrigerator between
two to eight degrees Celsius.